Overview: 

 Adapted to the gas stations, railways, factories, power plants and other indoor and outdoor venues fixed lighting. 

 A performance: 

 ① high-efficiency gas discharge lamp as the light source, and through advanced optical design and special treatment, even soft light, no glare, the average life of 10,000 hours or more. 
 ② the use of high strength aluminum alloy case and optimized structure design, with a strong anti-impact ability. 
 ③ the structural design and optimization of high-tech surface coating technology, protection grade IP65, to ensure that lighting does not corrode in the harsh environment, does not rust. 
 ④ A, B two kinds of optical design, in which A-type optical design is symmetric, B type asymmetric light distribution in two models, according to the needs of different lighting scene selection. 
 ⑤ independent chamber design, thermal performance, greatly improved the life of the lamp; easy maintenance and simple. 
 ⑥ compact structure, beautiful appearance, easy installation, can use a variety of embedded and ceiling installation. 

 Two uses: 

 ① According to the site environment and lighting needs, determine the appropriate installation method. 220V power supply based on contacts of the lamp to prepare the appropriate length from φ8 ~ φ10mm three-core cable. 
 ② ceiling mount: the expansion of using the two M8 screw or M8 hit the ceiling bolts fixed to the support of ordinary beam; embedded installation: Direct use four M6 screws fixed to the four corners of the mounting holes fixed lighting fixtures. 
 ③ installed bracket, screw lights ballast chamber cavity and locking screws, and opened a lamp shell (Ceiling way, ceiling installation) or ballast housing (screws embedded), the three-core cable wear Glen had waterproof connector, then the corresponding identity in connection with polar seat. Note, be sure to use pressed into the cable line card lock, to prevent the pull off. Embedded ceiling installation, after the lifting of advanced lighting cable re-positioning lamps. 
 ④ replace the lamp, first disconnect the power, unscrew the light fixed glass panel on the front of the screw, through the hanging chain structure, the panel light hanging lamp shell, you can unscrew the old bulb and put a new bulb. The replacement of other electrical components, open the ballast chamber, ready to replace any electrical components. 

 Three note: 

 ① lighting installation and maintenance, you must first disconnect the power. 
 ② Non-professionals may not disassemble lamp. 
 ③ use, the light surface of a certain temperature, is a normal phenomenon; transparent pieces of center temperature is higher, shall not touch. 
 ④ changing light bulbs, you should use the same type, the power of light bulbs; If you change the type of bulb or power, supporting the ballast should be replaced accordingly. 

 Four technical parameters: