Overview: 

 Widely used in various factories, workshops, field stations and other indoor and outdoor areas for cabin floodlights. 

 A performance: 

 ● the use of new electrodeless fluorescent lamps as the light source, enabling instant cold start and hot start. 
 ● Light source power factor> 0.95, high luminous efficiency, low power consumption, environmental protection, energy saving, color is good, no flicker, no glare, which can effectively avoid the discomfort of staff and fatigue, improve work efficiency. 
 ● up to 80,000 hours lamp life over the lifetime of the product without changing source. 
 ● light alloy material is using the air, using the latest surface coating technology, dustproof, waterproof, corrosion-resistant, do not fade, does not rust, to ensure reliable operation in outdoor long. 
 ● transparent bullet-proof materials imported plastic parts, light transmittance, high strength, corrosion resistance, excellent seismic performance. 
 ● The appearance is simple and elegant, small size and light weight. 

 Second use: 

 1, according to the site environment and the installation of lighting fixtures need to determine the location and lighting to 220V power supply according to the distance, ready for the appropriate length of the three-core cable. 
 2, the outer edge of surface cover lamp screw rotation, open the side cover, one end of the three core cable connector through the Glen, the introduction of lamp cavity, the FireWire connection with the L terminal, the zero line and the N terminal, ground and ground terminals, and screws were used to compress, and then recover the fixed surface cover. 
 3, the lamps installed at a predetermined fixed position, three-core power cable connected to the other end can be achieved with the lighting. 
 4, replace the lamp, the first outer edge of surface cover lamp screw rotation, remove the transparent parts, open the ballast on the insulation panels, then the wires connected to the lamp and ballast removed, spin screws under the lamp, remove the old lamp, put on new tube, and screwed the lamp shell, the plug on the lamp socket and ballast on the butt, and then covered with insulation board, will face Reset lid and firmly fixed. 

 C Note: 

 1, the transportation will be equipped with lamps installed in the carton, and add the foam cushioning. 
 2, when used, has some light surface temperature is normal. 
 3, replacing the lamp, be sure to first cut off the power. 
 4, the lamp proper installation height is 2 to 4.5 meters and a maximum projection range Ф7 meters. 
 5, if the external flexible cable or a lamp cord is damaged, and the line up to the manufacturer or its service agent or a qualified person replaced. 

 Four Technical Data: