For flammable and explosive and a variety of indoor and outdoor work sites, construction site, etc. as fixed emergency lighting. 


 A performance: 

 / Explosion-proof lamps, can be safe in explosive hazardous areas work. 

 / MH discharge lamps with high efficiency as the light source, high luminous efficiency, the average life of 10,000 hours or more. 

 / Light body with light alloy material, high strength, corrosion resistance, impact resistance; transparent pieces of glass with sweeping special high temperature, expanding the space for heat dissipation, reducing the temperature rise and increase bulb life. 

 / Light surface spray using the latest technology, not color, not rust, can prevent water and rain, but also long-term use outdoors. 

 / Small size, light weight, can be pendant, wall, ceiling and pole-type and other installation, simple operation. 

 Second use: 

 1, lamps and ballasts to determine the installation location, select the appropriate installation, and ready the appropriate length of a special three-core cable. 
 2, lamps and ballasts with screws fixed installation, and then the lights M6 Allen wrench loosen the screws around the cover, opened a lamp cover. 
 3, with a screwdriver unscrew the light bulb screw base, the prepared end of three core cable into the device through the compression nut cavity into light wiring; red and blue cord to the lamp, the yellow line to ground online; connected line, the lamp base tighten the fixing screws, the lamp cover is closed, and then around the lamp cover screws tightened. 
 4, the three core cable the other end of the introduction through ballast output devices, corresponding to the terminal by receiving the ballast terminals marked. 
 5, the proposed one end of the cable connecting the power input through the introduction of ballast device, receiving input terminals, and then close the top cover ballasts and tighten the screw, and then press against the other end of cable can be connected to 220V power burst required lighting. 

 Warning: 
 1, the non-charged open lamps. 
 2, non-professionals are not free to install, remove lamps and ballasts. 

 C Note: 

 1, must use a special ballast with the company. 
 2, installation and maintenance of lamps, it must first cut off the power. 
 3, transparent pieces of center temperature is higher, do not touch. 
 4, replace the lamp, you should use the same type of light bulbs; if the model or the power to change light bulbs, ballasts should be replaced accordingly. 
 5, lamp starting current is 2.5 times the normal operating current, 150W lamp starting current of 1.7A, 35W lamp starting current of 0.4A. 

 Four Technical Data: 

 Rated voltage: 220VAC 

 Lamp type: MH Discharge 

 Protection class: IP65 

 Dimensions: 375 × 264 × 167mm 

 Weight: 3.5kg