Overview: 

 For petrochemical plants, workshops and a wide range of offshore oil platforms and other inflammable and explosive places. 


 A performance: 

 / Explosion proof the highest level, can be safe in explosive hazardous areas of work; 

 / High-intensity gas discharge lamp as light source, high luminous efficiency, the average life of 10,000 hours or more; 

 / Crystalline glass with edge, no glare, can effectively prevent the construction workers of discomfort and fatigue; 

 / Uses the integrated density of the whole design and the latest surface treatment technology, beautiful appearance, easy installation, anti-rain, water, light shell never corrosion, rust, can be hot and humid and corrosive and other harsh environments long-term use; 

 / High strength aluminum alloy case with strong resistance to impact and shock resistance. 

 Second use: 

 1, according to the actual work site lighting needs to determine where and how to install lighting, and then press the lamp into the 220V power supply contacts the appropriate length of the distance of three ready-core cable (such as use of steel pipe will be the introduction of three-core cable to pipe lamps installed Office); 
 2, first remove the screw on the wiring cavity, pull out some of the wiring junction box; from its packaging and remove the seals and fittings (with set screws), followed by set into the cable; and then one end of the three-core cables were access box logo "L", "N" and the ground on, with the pressure line card pinched cable, and fixed with screws, then tighten the fittings, compression seals, and from the side of the set screw firmly screws; 
 3, step 2 part screw steel pipes, installed from the side locking set screws, and then light body along the rail into the junction box and tighten the screws on the panel; 
 4, the last three core cable to the other end connected to 220V power supply according to proof requirements. 
 5, replace the lamp, the first cut off the power, then remove the hex wrench set screws on the shell, with a large screwdriver or other tool to loosen the lamp cover 6 laps, and then slowly by hand carefully remove the lamp cover, spin replace the old light bulb under the new lamp. 

 Warning: 
 1) Do not open the lamp charged; 
 2) Remove the light cover, light cover and light housing with care when out soon. 

 C Note: 

 1, the installation and maintenance of lamps, you must cut off the power supply, refer to wiring diagram; 
 2, when used, has some light surface temperature is a normal phenomenon, transparent pieces of center temperature is higher, shall not touch; 
 3, must be equipped with electrical appliances of the company; 
 4, replace the lamp, you should use the same type, the power of the bulb; If you change the bulb type or power, shall replace the corresponding supporting ballast. 

 Four Technical Data: 

 Rated Voltage: 220VAC 50Hz 

 Enclosure protection: IP65 

 Inlet thread: G3 / 4 

 Drop Cable: φ8 ~ φ14mm 

 Dimensions: 540 × 364 × 192mm 

 Total weight: 11Kg 

 V. Quality Assurance: 

 This product is in strict accordance with ISO9001: 2000 International